Simply put, solenoids are basically electrical components that have numerous applications. They work on a few basic principles. Its main function is to transfer electric current from the battery to the starter. It is activated as soon as you turn the key and the car starts.

The following information will help you test and check your starter solenoid. If you want to be prepared, read below.

  1. Listen to the engine

Make a habit out of listening to the sounds that your car makes. In this case, be sure to observe the noises that result when you start or turn off the car. More specifically, listen carefully when you turn the key and the vehicle jumps into ignition.

  1. Focus on clicking sounds

Sometimes, you may hear some out of the ordinary clicking sounds coping from your car. These are usually a result of a faulty or defective starter solenoid. Even if you do not hear the noise, check the components regularly that may produce these sounds. The chances of them being defective are still likely.

  1. Engine failure

One fairly obvious sign of a faulty starter solenoid will be when your car refuses to start. Your dashboard lights might be on but, the engine will not crank up. This means that there is a problem with the solenoid.

  1. Check the meter

Turn on the meter and ask someone to start the car. The reading of the voltage should be either 0.2 volts or less. If the reading is higher than this, then you need to check the wires for corrosion or dust. Clean them and then plug them back in for maximized potential.

With this guide in your hand, you can take charge of the situation. Using the instructions above, you will not get confused by any complications. Best of luck!